LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1140 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Forward Servo Replacement (M15 (FWD)) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Forward Servo Assembly
    GM164777Courtesy of GENERAL MOTORS CORP.
  1. Install the servo spring.
  2. Install the servo piston assembly.
  3. Install the forward servo cover O-ring.
  4. Install the forward servo cover.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the forward band servo cover bolts.

    Tighten:  Tighten the forward band servo cover bolts to 12 N.m (106 lb in).

  6. Remove the drain pan from under the forward servo cover.
    7. IMPORTANT: Ensure that the power steering cooler line does not become trapped or damaged during this step.
  7. Use the utility stand in order to raise the frame rear.
  8. Install the NEW frame bolts.
  9. Install the powertrain mounts to the frame.
  10. Install the transaxle mount nuts. Refer to Automatic Transmission Mount Replacement .
  11. Install the engine mount nuts. Refer to Engine Mount Replacement in Engine Mechanical.
  12. Install the power steering gear to the frame. Refer to Power Steering Gear Replacement in Power Steering System.
  13. Install the power steering gear heat shield. Refer to Power Steering Gear Heat Shield Replacement in Power Steering System.
  14. Install the stabilizer shaft. Refer to Stabilizer Shaft Replacement in Front Suspension.
  15. Lower the vehicle.
  16. Remove the engine support fixture. Refer to Engine Support Fixture in Engine Mechanical.
scientia non olet · About LEMON Manuals