LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1140 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Flywheel to Torque Converter Bolt Replacement (LY7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Torque Converter Bolts
    GM1395491Courtesy of GENERAL MOTORS CORP.
  1. Install the torque converter bolts.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Use J 43442 to hold the flywheel.

    Tighten:  Tighten the torque converter bolts to 60 N.m (44 lb ft).

  3. Install the starter. Refer to Starter Motor Replacement (LA1) or Starter Motor Replacement (LY7) in Engine Electrical.
    4. Fig 2: Locating Torque Converter Cover Bolts (LY7)
    GM1409587Courtesy of GENERAL MOTORS CORP.
  4. Install the torque converter cover. Refer to Torque Converter Cover Replacement (LA1)  or Torque Converter Cover Replacement (LY7) .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals