Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Flywheel To Torque Converter Bolts

Courtesy of GENERAL MOTORS CORP.

Install the flywheel to torque converter bolts.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Use the J 37623 to hold the flywheel.
Tighten: Tighten the bolts to 63 N.m (47 lb ft).

Fig 2: Identifying Torque Converter Cover Bolts

Courtesy of GENERAL MOTORS CORP.

Install the torque converter cover. Refer to Torque Converter Cover Replacement (LA1) or Torque Converter Cover Replacement (LY7) .
Lower the vehicle.