LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1140 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Fluid Filler Tube Replacement (LY7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Do NOT place the fluid filler tube seal on the fluid filler tube when installing the tube or damage to the seal will result.
  1. Install the fluid filler tube seal to the transaxle.
  2. Install the transmission fluid filler tube.
    3. Fig 1: View Of Fluid Filler Tube Nut
    GM1408490Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the fluid filler tube bolt.

    Tighten:  Tighten the filler tube bolt to 13 N.m (115 lb in).

  4. Install the transfer case vent tube to the transmission filler tube. Refer to Vent Hose Assembly Replacement (LA1) or Vent Hose Assembly Replacement (LY7) in Transfer Case - Steyr.
  5. Install the engine coolant (block) heater cord to the transmission filler tube. Refer to Coolant Heater Cord Replacement (LA1) or Coolant Heater Cord Replacement (LY7) in Engine Cooling.
    6. Fig 2: Supporting Rear Frame & Powertrain With Utility Stand
    GM1388664Courtesy of GENERAL MOTORS CORP.
  6. Raise the powertrain until the frame insulators contact the chassis.
  7. Install the frame bolts. Refer to Frame Replacement - Front (W/AWD) or Frame Replacement - Front (W/FWD) in Frame and Underbody.
  8. Connect the intermediate steering shaft to the steering gear. Refer to Intermediate Steering Shaft Replacement in Steering Wheel and Column.
  9. Lower the vehicle.
  10. Install the fluid filler tube nut.

    Tighten:  Tighten the filler tube nut to 13 N.m (115 lb in).

  11. Install the oil level indicator from the filler tube.
  12. Install the air cleaner. Refer to Air Cleaner Assembly Replacement in Engine Controls - 3.6L (LY7).
  13. Inspect and adjust the fluid level as needed. Refer to the following information:
scientia non olet · About LEMON Manuals