LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1140 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Case Porosity >> Repair Procedure

Repair Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Use solvent to clean the leak area.
  2. Use compressed air to dry the area.
    3. CAUTION: Epoxy adhesive may cause skin irritations and eye damage. Read and follow all information on the container label as provided by the manufacturer.
  3. Follow the manufacturer's recommendations to mix a sufficient amount of GM P/N 1052533, or equivalent, epoxy cement.
  4. Use a clean and dry soldering acid brush to apply the epoxy cement while the transaxle case is hot.
  5. Allow the epoxy cement to cure for three hours.
  6. Start the engine.
  7. Repeat the fluid leak diagnosis procedures.
scientia non olet · About LEMON Manuals