LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1140 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Automatic Transmission Range Selector Cable Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Automatic Transaxle Range Selector Cable Bracket Bolts
    GM161088Courtesy of GENERAL MOTORS CORP.
  1. Install the automatic transaxle range selector cable bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the automatic transaxle range selector cable bracket bolts.

    Tighten:  Tighten the automatic transaxle range selector cable bracket bolts to 25 N.m (18 lb ft).

  3. Install the automatic transaxle range selector cable to the cable lever and the bracket. Refer to Automatic Transmission Range Selector Cable Replacement .
  4. Adjust the automatic transaxle range selector cable. Refer to Automatic Transmission Range Selector Cable Adjustment .
  5. Install the throttle body air inlet duct. Refer to Air Cleaner Assembly Replacement in Engine Controls-3.4L.
scientia non olet · About LEMON Manuals