LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1140 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Automatic Transmission Mount Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the left front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the left engine splash shield. Refer to Splash Shield Replacement - Engine in Body Front End.
  4. Use a utility stand with a block of wood in order to support the transaxle.
    5. Fig 1: View Of Transaxle Mount Upper Nuts
    GM368791Courtesy of GENERAL MOTORS CORP.
  5. Remove the transaxle mount upper nuts.
    6. Fig 2: View Of Transaxle Mount Bracket And Bolts
    GM161246Courtesy of GENERAL MOTORS CORP.
  6. Remove the transaxle mount bracket bolts.
  7. Remove the transaxle mount bracket.
scientia non olet · About LEMON Manuals