LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Engine Controls - Removal, Overhaul & Installation) >> Ignition Systems >> Ignition Coil(S) >> Removal (4.0L - Bank 2)

Removal (4.0L - Bank 2)

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue and 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Bank 2 is the cylinder head that is closest to the front of engine compartment. Turn ignition off. Remove mounting the 2 mounting nuts from the injector sight shield (top engine cover). Lift the injector sight shield off the mounting studs by lifting at the front of the cover. Disconnect the bank 2 Ignition Control Module (ICM) electrical connector.
  2. Using the removal sequence, remove the ignition cassette retaining bolts. See Figure. Carefully remove the ignition cassette. Remove ignition coil(s) from ignition cassette as necessary.
scientia non olet · About LEMON Manuals