LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Engine Controls - Removal, Overhaul & Installation) >> Fuel Systems >> Fuel Tank >> Removal (Intrigue)

Removal (Intrigue)

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue and 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE . Drain the fuel tank. See FUEL TANK DRAINING .
  2. Loosen the fuel filler hose clamp from the fuel tank. Remove the fuel tank filler hose from the fuel tank. Disconnect the quick-connect fittings from the front of the fuel tank. See FUEL LINE DISCONNECT FITTINGS .
  3. Disconnect the EVAP pipe from the connection at the front of the fuel tank. Remove the rubber exhaust pipe hangers in order to allow the exhaust system to drop slightly. Separate the two halves of the EVAP fresh air hose at the splice. Remove the 3 push pins and the fuel tank shield. Support the fuel tank with a suitable transmission jack.
  4. Remove the fuel tank strap bolts. Lower the fuel tank to access the EVAP hose connections. Disconnect the EVAP pipes from the rear of the fuel tank. Disconnect the EVAP pipe from the EVAP canister vent valve. Disconnect the fuel filler neck EVAP pipe at the rear of the fuel tank. Slowly lower fuel tank and remove the fuel tank from the vehicle.
scientia non olet · About LEMON Manuals