LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Engine Controls - Removal, Overhaul & Installation) >> Fuel Systems >> Fuel Tank Pressure Sensor >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue and 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear compartment floor trim. Remove spare tire cover, jack and spare tire, if necessary. Remove the fuel sender access panel bolts. Remove the fuel sender access panel. Disconnect fuel tank pressure sensor electrical connector. See Figure. Remove fuel tank pressure sensor. To install, reverse removal procedure.