LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Engine Controls - Removal, Overhaul & Installation) >> Engine Sensors & Switches >> Manifold Absolute Pressure Sensor >> Removal (4.0L)

Removal (4.0L)

WARNING: This page is about a different car, the 2002 Oldsmobile Intrigue and 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition off. Disconnect the Manifold Absolute Pressure (MAP) sensor harness connector. See Figure. Remove the cable bracket bolts and bracket. Remove the MAP sensor from the intake manifold.
  2. Disconnect the MAP sensor electrical connector. Inspect the MAP sensor grommet for wear or damage. Replace grommet as necessary.
scientia non olet · About LEMON Manuals