LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1137 (Seat Belt System) >> Repair Instructions >> Shoulder Belt Guide Adjuster Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: Verify that the release lever is at the top of the adjuster bracket in the full up position.
    Fig 1: Locating Shoulder Belt Guide Belt Adjuster Bracket
    GM620839Courtesy of GENERAL MOTORS CORP.
  1. Install the shoulder belt guide adjuster bracket to the center pillar.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolt to the shoulder belt guide belt adjuster bracket.

    Tighten:  Tighten the shoulder belt guide adjuster bracket bolts to 42 N.m (31 lb ft).

  3. Install the center pillar upper trim panel. Refer to Trim Panel Replacement - Upper Center Pillar in Interior Trim.
scientia non olet · About LEMON Manuals