LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1137 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - No. 2 Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear No. 2 seat. Refer to Seat Replacement - Rear No. 2 (Buick) in Seats.
    2. Fig 1: No. 2 Rear Seat Belt Guide Loop
    GM786759Courtesy of GENERAL MOTORS CORP.
  2. Open the cover from the seat belt guide loop.
    3. Fig 2: Seat Belt Guide Loop Bolt
    GM786753Courtesy of GENERAL MOTORS CORP.
  3. Remove the bolt from the seat belt guide loop.
    4. Fig 3: View Of Pillar Trim Panel
    GM786752Courtesy of GENERAL MOTORS CORP.
  4. Remove the pillar trim panel from the vehicle.
  5. Remove the liftgate door sill plate. Refer to Door Sill Plate Replacement - Liftgate (Rendezvous) in Interior Trim.
  6. Remove the lower anchor bolt from the seat belt.
    7. Fig 4: Locating Cargo Tie-Down Location Bolts
    GM785351Courtesy of GENERAL MOTORS CORP.
  7. Remove the bolts from the cargo tie-down locations.
  8. Pull the rear quarter trim panel away from the vehicle.
    9. Fig 5: View Of Rear Seat Belt Bolt To The Body
    GM363681Courtesy of GENERAL MOTORS CORP.
  9. Remove the bolt (1) that retains the rear seat belt to the body.
  10. Remove the seat belt retractor from the vehicle.
scientia non olet · About LEMON Manuals