Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Seat Belt Bolt To The Body

Courtesy of GENERAL MOTORS CORP.

Install the seat belt retractor to the vehicle.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolt (1) that retains the rear retractor to the body.
Tighten: Tighten the retractor bolt to 43 N.m (32 lb ft).

Fig 2: Locating Cargo Tie-Down Location Bolts

Courtesy of GENERAL MOTORS CORP.

Install the quarter trim panel to the vehicle.
Install the bolts to the cargo tie-down locations.
Tighten: Tighten the loop bolts to 6 N.m (53 lb in).
Install the lower seat belt anchor bolt.
Tighten: Tighten anchor bolt to 43 N.m (32 lb ft).
Install the liftgate door sill plate. Refer to Door Sill Plate Replacement - Liftgate (Rendezvous) in Interior Trim.

Fig 3: View Of Pillar Trim Panel

Courtesy of GENERAL MOTORS CORP.

Install the pillar trim to the vehicle.
Install the bolt that secures the seat belt guide loop.
Tighten: Tighten the bolt to 43 N.m (32 lb ft).

Fig 4: Seat Belt Guide Loop Bolt

Courtesy of GENERAL MOTORS CORP.

Close the cover to the seat belt guide loop.

Fig 5: No. 2 Rear Seat Belt Guide Loop

Courtesy of GENERAL MOTORS CORP.

Install the rear No. 2 seat. Refer to Seat Replacement - Rear No. 2 (Buick) in Seats.