LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1137 (Seat Belt System) >> Repair Instructions >> Seat Belt Buckle Replacement - Rear (Bucket) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Bucket Seat Belt Buckle Anchor Stud Retaining Nut
    GM627488Courtesy of GENERAL MOTORS CORP.
  1. Install the rear seat belt buckle to the right and/or left rear seat belt anchor stud.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nut to the right and/or left rear bucket seat belt buckle anchor stud.

    Tighten:  Tighten the right and/or left rear seat belt buckle anchor nut to 42 N.m (31 lb ft).

    3. Fig 2: Identifying Bucket Seat Belt Buckle Anchor Stud Nut Cover Cup
    GM627486Courtesy of GENERAL MOTORS CORP.
  3. Install the nut cover cup to the right and/or left rear bucket seat belt buckle anchor stud turning clockwise until fully seated.
  4. Install the right and/or left rear bucket seat to the vehicle. Refer to Seat Replacement - Rear Bucket in Seats.
scientia non olet · About LEMON Manuals