LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1135 (Hydraulic Brake System) >> Repair Instructions >> Master Cylinder Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Master Cylinder Reservoir
    GM621483Courtesy of GENERAL MOTORS CORP.
  1. Install the master cylinder reservoir. Refer to Master Cylinder Reservoir Replacement .
  2. Bench bleed the master cylinder prior to installation. Refer to Master Cylinder Bench Bleeding .
  3. Install the master cylinder.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the master cylinder mounting nuts.

    Tighten:  Tighten the master cylinder mounting nuts to 25 N.m (18 lb ft).

  5. Connect the fluid level sensor electrical connector.
  6. Connect the brake pipes to the master cylinder.

    Tighten:  Tighten the master cylinder tube nuts to 15 N.m (11 lb ft).

  7. Fill the master cylinder reservoir with brake fluid. Refer to Master Cylinder Reservoir Filling .
  8. Bleed the brake system. Refer to Hydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure) .
scientia non olet · About LEMON Manuals