LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1135 (Hydraulic Brake System) >> Repair Instructions >> Brake Pedal Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zones in SIR.
  2. Remove the left side insulator panel. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
    3. Fig 1: Locating Brake Pedal Assembly Components
    GM180291Courtesy of GENERAL MOTORS CORP.
  3. Remove the booster push rod (2) from the brake pedal (1).
  4. Disconnect the electrical connectors from the cruise control release if equipped and stop lamp switch.
  5. Remove the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
  6. Remove the brake booster mounting nuts (3).
    7. Fig 2: Identifying Brake Pedal Assembly Components
    GM180294Courtesy of GENERAL MOTORS CORP.
  7. Remove the brake pedal bracket mounting nuts (2).
  8. Remove the upper mounting nuts (1) from the brake pedal brace (4).
  9. Remove the brake pedal with the bracket (3).
  10. Remove the brake pedal brace (4) from the bracket.
    11. Fig 3: Locating Stop Lamp Switch & Cruise Control Switch
    GM180295Courtesy of GENERAL MOTORS CORP.
  11. Remove the cruise control release switch (3), if equipped, and the stop lamp switch (1) from the brake pedal with the bracket (2).
scientia non olet · About LEMON Manuals