LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1134 (Engine Mechanical (Repair Instructions 2 Of 5) - 3.6L (Ly7)) >> Repair Instructions (On-Vehicle Part 2 & Off-Vehicle Part 1) >> On-Vehicle Repair Instructions - Part 2 >> Oil Pump Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pump & Mounting Bolts
    GM902821Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not remove the left bank idler sprocket.
  1. Remove the primary timing chain. Refer to Primary Camshaft Drive Chain and Sprockets Replacement .
  2. Remove the crankshaft sprocket. Refer to Crankshaft Sprocket Removal .
  3. Remove the oil pump bolts and the oil pump. Refer to Oil Pump Removal .
  4. Perform the following steps as necessary:
scientia non olet · About LEMON Manuals