LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1134 (Engine Mechanical (Repair Instructions 2 Of 5) - 3.6L (Ly7)) >> Repair Instructions (On-Vehicle Part 2 & Off-Vehicle Part 1) >> Off-Vehicle Repair Instructions - Part 1 >> Water Pump Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EN 46104 Installed On Water Pump Pulley
    GM1412158Courtesy of GENERAL MOTORS CORP.
  1. Install the EN 46104  onto the water pump pulley.
    2. Fig 2: Locating Water Pump Pulley & Bolts
    GM1412160Courtesy of GENERAL MOTORS CORP.
  2. Remove the water pump pulley bolts.
  3. Remove the water pump pulley.
    4. Fig 3: Identifying Water Pump Components
    GM1412162Courtesy of GENERAL MOTORS CORP.
  4. Remove the water pump bolts.
  5. Remove the water pump from the front cover.
  6. Remove the water pump gasket.
scientia non olet · About LEMON Manuals