LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1134 (Engine Mechanical (Repair Instructions 2 Of 5) - 3.6L (Ly7)) >> Repair Instructions (On-Vehicle Part 2 & Off-Vehicle Part 1) >> Off-Vehicle Repair Instructions - Part 1 >> Drive Belt Removal

Drive Belt Removal

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Drive Belt Tensioner & Pulleys
    GM284263Courtesy of GENERAL MOTORS CORP.
  1. Insert a 1/2 inch drive ratchet into the outer drive belt tensioner.
  2. Rotate the drive belt tensioner clockwise.
  3. Remove the drive belt from around the drive belt idler pulley.
  4. Slowly rotate the drive belt tensioner counterclockwise.
  5. Remove the 1/2 inch drive ratchet.
    6. Fig 2: Identifying Drive Belt
    GM1395907Courtesy of GENERAL MOTORS CORP.
  6. Remove the drive belt from around the following:
    • Crankshaft balancer
    • Generator
    • Air conditioning compressor
    • Power steering pump pulley
    • Water pump pulley
    • Drive belt tensioner
scientia non olet · About LEMON Manuals