LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1132 (Wheel Alignment Specifications & Adjustment Procedures) >> Repair Instructions >> Rear Camber Adjustment (AWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place vehicle on alignment machine with rear wheels supported by Weaver plates.
    2. Fig 1: Identifying Lower Control Arm To Crossmember Mounting Bolts
    GM629235Courtesy of GENERAL MOTORS CORP.
  2. Loosen (3, 4).
  3. Adjust camber with cam bolt (1).
  4. Confirm correct camber value.
  5. Check toe alignment and adjust if required.
scientia non olet · About LEMON Manuals