LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1131 (Parking Brake System) >> Repair Instructions >> Park Brake Warning Lamp Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the park brake indicator switch.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the park brake indicator switch screw.

    Tighten:  Tighten the park brake indicator switch screw to 3 N.m (27 lb in).

    3. Fig 1: Locating Parking Brake Switch Electrical Connector
    GM181465Courtesy of GENERAL MOTORS CORP.
  3. Install the park brake indicator switch electrical connector.
  4. Install the left-side door sill plate. Refer to Door Sill Plate Replacement - Front in Interior Trim.
  5. Install the left-side instrument panel insulator. Refer to Trim Panel Replacement - Cowl Side in Interior Trim.
scientia non olet · About LEMON Manuals