LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1131 (Parking Brake System) >> Repair Instructions >> Park Brake Pedal Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Park Brake Cable End
    GM177096Courtesy of GENERAL MOTORS CORP.
  1. Install the switch, if removed.
  2. Install the cable to the new parking brake lever.
  3. Install the cable end to the lever clevis.
    4. Fig 2: Identifying Cable End To Lever Clevis
    GM179640Courtesy of GENERAL MOTORS CORP.
  4. Install the new parking brake lever.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the three lever to body mounting nuts.

    Tighten:  Tighten parking brake lever mounting nuts to 25 N.m (18 lb ft).

  6. Connect the electrical connector at the parking brake switch.
    7. Fig 3: Locating Rear/Front Park Brake Cable At Connector Clip
    GM179662Courtesy of GENERAL MOTORS CORP.
  7. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  8. Feed the cable through the underbody and clip the cable into place.
    9. Fig 4: View Of Equalizer Assembly
    GM474301Courtesy of GENERAL MOTORS CORP.
  9. Tighten the parking brake cable at the equalizer.
  10. Lower the vehicle.
  11. Position the carpet in place.
  12. Install the left side insulator panel. Refer to Trim Panel Replacement - Cowl Side in Interior Trim.
  13. Adjust the parking brake. Refer to Park Brake Adjustment (Disc)  or Park Brake Adjustment (Drum) .
scientia non olet · About LEMON Manuals