LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1131 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left-side instrument panel insulator. Refer to Trim Panel Replacement - Cowl Side in Interior Trim.
  2. Remove the left-side door sill plate. Refer to Door Sill Plate Replacement - Front in Interior Trim.
  3. Fold back the carpet for access.
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    5. Fig 1: View Of Equalizer Assembly
    GM474301Courtesy of GENERAL MOTORS CORP.
  5. Loosen the park brake cable equalizer nut in order to remove the park brake left side cable from the park brake equalizer.
    6. Fig 2: Locating Park Brake Cable Connector
    GM474297Courtesy of GENERAL MOTORS CORP.
  6. Remove the park brake cable end from the park brake cable connector.
  7. Remove the park brake cable from the park brake cable equalizer.
    8. Fig 3: View Of Park Brake Cable Guides
    GM181477Courtesy of GENERAL MOTORS CORP.
  8. Remove the park brake cable from the park brake cable guides.
  9. Remove the park brake cable nuts from the underbody studs.
  10. Remove the park brake cable clips from the park brake cable.
  11. Lower the vehicle.
    12. Fig 4: View Of Park Brake Cable End
    GM177096Courtesy of GENERAL MOTORS CORP.
  12. Remove the park brake cable end from the park brake lever clevis.
    13. Fig 5: Removing Cable From Lever
    GM177173Courtesy of GENERAL MOTORS CORP.
  13. Use the J 37043  in order to remove the cable from the lever.
  14. Remove the front park brake cable from the vehicle.
scientia non olet · About LEMON Manuals