LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1131 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the front park brake cable to the vehicle.
  2. Fig 1: View Of Park Brake Cable To Park Brake Lever
    GM181468Courtesy of GENERAL MOTORS CORP.
  3. Install the park brake cable to the park brake lever.
  4. Fig 2: View Of Park Brake Cable End
    GM177096Courtesy of GENERAL MOTORS CORP.
  5. Install the park brake cable end to the park brake lever clevis.
  6. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  7. Fig 3: View Of Park Brake Cable Guides
    GM181477Courtesy of GENERAL MOTORS CORP.
  8. Install the park brake cable clips to the park brake cable shielded areas.
  9. NOTE: Refer to Fastener Notice in Cautions and Notices.
  10. Install the park brake cable nuts to the underbody studs.

    Tighten:  Tighten the park brake cable nuts to 3 N.m (27 lb in).

  11. Install the park brake cable to the park brake cable guides.
  12. Install the park brake cable to the park brake equalizer.
  13. Fig 4: Locating Park Brake Cable Connector
    GM474297Courtesy of GENERAL MOTORS CORP.
  14. Install the park brake cable end to the park brake cable connector.
  15. Fig 5: View Of Equalizer Assembly
    GM474301Courtesy of GENERAL MOTORS CORP.
  16. Install the park brake left side cable to the park brake equalizer.
  17. Adjust the park brake cable. Refer to Park Brake Adjustment (Disc)  or Park Brake Adjustment (Drum) .
  18. Lower the vehicle.
  19. Fold the carpet back in place.
  20. Install the left-side door sill plate. Refer to Door Sill Plate Replacement - Front in Interior Trim.
  21. Install the left-side instrument panel insulator. Refer to Trim Panel Replacement - Cowl Side in Interior Trim.