LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1131 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Equalizer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the left rear park brake cable and adjustment stud assembly from the equalizer assembly by removing the equalizer nut from the adjustment stud.
    3. Fig 1: View Of Front Brake Cable Connected To Right Rear Cable
    GM717002Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the front park brake cable (1) from the right rear cable (3) at the connector clip (2).
    4. Fig 2: Installing/Removing Equalizer Assembly From Front Park Brake Cable
    GM717006Courtesy of GENERAL MOTORS CORP.
  4. Remove the equalizer assembly from the front park brake cable. Use a flat bladed tool to release the assembly from the cable.
scientia non olet · About LEMON Manuals