Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Inflator Solenoid

Courtesy of GENERAL MOTORS CORP.

Install the inflator solenoid to the air compressor assembly bracket.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screws (3) into the inflator solenoid and the air compressor bracket.
Tighten: Tighten the screws to 6 N.m (53 lb in).
Install the electrical connector (2) onto the inflator solenoid.
Install the hoses (1) onto the inflator solenoid.
Lower the vehicle.