LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1130 (Suspension Control System - Suspension Leveling) >> Repair Instructions >> Air Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Air Tubes Connected To Shock Absorbers
    GM517949Courtesy of GENERAL MOTORS CORP.
  1. Install the right rear air tube on the vehicle in the routing clips.
  2. Connect the right rear air tube to the tee connector.
  3. Connect the right rear air tube to the right rear shock absorber.
  4. Connect the left rear air tube to the tee connector.
  5. Connect the left rear air tube to the right rear shock absorber.
    6. IMPORTANT: Before driving the vehicle, turn the ignition on and wait approximately 45 seconds. This will ensure that the air adjustable shock absorbers are filled with residual pressure.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals