LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1130 (Suspension Control System - Suspension Leveling) >> Repair Instructions >> Accessory Fill Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Accessory Fill Valve Access Cover
    GM865447Courtesy of GENERAL MOTORS CORP.
  1. Install the accessory fill valve into the trim panel.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the washer (4) and the nut (3) to the accessory fill valve.

    Tighten:  Tighten the accessory fill valve nut to 6 N.m (53 lb in).

  3. Install the cap to the accessory fill valve.
  4. Install the hose (1) onto the accessory fill valve (5).
  5. Install the lower rear quarter trim panel. Refer to Trim Panel Replacement - Rear Quarter Lower (Aztek) or Trim Panel Replacement - Rear Quarter Lower (Rendezvous) in Interior Trim.
  6. Install the accessory fill valve access cover.
scientia non olet · About LEMON Manuals