LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1130 (Suspension Control System - Suspension Leveling) >> Diagnostic Information and Procedures >> DTC 022 >> Test Description

Test Description

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

The number(s) below refer to the step number(s) on the diagnostic table.

  1. 2:  Tests for battery positive voltage at the relay coil. The ELC fuse supplies power to the relay coil of the compressor relay.
  2. 3:  Verifies that the height sensor is providing ground to the compressor relay.
  3. 4:  Tests if battery positive voltage is constantly being applied to the compressor relay control circuit or the circuit is open.
  4. 9:  Verifies that the sensor is self tested after replacement.
DTC 022

Step Action Yes No
Schematic Reference:  Automatic Level Control Suspension Schematics  
1 Did you perform the Automatic Level Control Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Automatic Level Control (With Inflator) 
2 
  1. Turn ON the ignition.
  2. Disconnect the compressor relay.
  3. Probe the battery positive voltage circuit of the compressor relay with a test lamp that is connected to a good ground.
Does the test lamp illuminate?		 Go to Step 3  Go to Step 7 
3 
  1. Connect a test lamp between the coil control circuit of the compressor relay and the battery positive voltage circuit of the compressor relay.
  2. With the accessory inflator switch, command the accessory inflator solenoid ON and OFF.
Does the test lamp turn ON and OFF with each command?		 Go to Step 5  Go to Step 4 
4  Test the control circuit of the compressor relay for a short to voltage, ground or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 10  Go to Step 6 
5 Inspect for poor connections at the compressor relay. Refer to Testing for Intermittent Conditions and Poor Connections and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 10  Go to Step 8 
6 Inspect for poor connections at the harness connector of the height sensor. Refer to Testing for Intermittent Conditions and Poor Connections and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 10  Go to Step 9 
7 Repair the battery positive voltage circuit of the compressor relay coil. Refer to Wiring Repairs in Wiring Systems.
Did you complete the repair?		 Go to Step 10  -
8 Replace the compressor relay. Refer to Automatic Level Control Relay Replacement 
Did you complete the replacement?		 Go to Step 10  -
9 
IMPORTANT: System untested code will continue to flash until self test has been completed after sensor replacement.
Replace the height sensor. Refer to Automatic Level Control Sensor Replacement .Did you complete the replacement?		 Go to Step 10  -
10 Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
scientia non olet · About LEMON Manuals