Removal & Installation (3.1L & 3.4L)
WARNING: This page is about a different car, the 2002 Pontiac Grand Am, 2002 Oldsmobile Alero, and 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect spark plug wires from the ignition coil(s). Note the position from which the wires are removed. Remove 2 screws securing the ignition coil to the ignition control module. Remove the ignition coil. To install, reverse removal procedure. Tighten ignition coil screws to specification. See TORQUE SPECIFICATIONS . Reconnect spark plug wires. See Fig 1 .