Crankshaft Position Sensor "B": Installation
WARNING: This page is about a different car, the 2002 Pontiac Grand Am, 2002 Oldsmobile Alero, and 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Lubricate the "O" ring with clean engine oil before installation and replace if damaged. Install the CKP sensor to the block. Install the CKP sensor attaching bolt and tighten to specification. See TORQUE SPECIFICATIONS .
- Connect the CKP sensor electrical connector. Install the right tire and wheel. Tighten wheel lug nuts to specification. Lower the vehicle. Perform the CKP system variation learn procedure. See PROGRAMMING in SELF-DIAGNOSTICS - 3.1L CENTURY, GRAND PRIX & MALIBU article or PROGRAMMING in SELF-DIAGNOSTICS - 3.4L ALERO, GRAND AM, IMPALA & MONTE CARLO article.