LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Engine Controls - Removal & Installation, Overhaul) >> Fuel Systems >> Fuel Tank >> Installation

Fuel Tank: Installation

WARNING: This page is about a different car, the 2002 Pontiac Grand Am, 2002 Oldsmobile Alero, and 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the aid of an assistant, raise the fuel tank to the vehicle. Connect wiring harness connectors and EVAP pipes as necessary.
  2. Install the fuel tank retaining straps. Tighten the strap bolts to specification. See TORQUE SPECIFICATIONS  . Connect the wiring harness into the multiway rear body connector. Connect the EVAP vapor pipe to the EVAP canister.
  3. Connect the fuel filler hose to the fuel tank. Tighten the fuel filler hose clamp to specification. Install the rubber exhaust hangers. Install the exhaust heat shield. Tighten the exhaust shield bolt/nuts to specification. Connect the fuel return pipe and fuel filter quick-connect fittings. Lower the vehicle. Refill the fuel tank. Install the fuel filler cap.
  4. Inspect for leaks by using the following procedure.
    • Turn ignition on for 2 seconds.
    • Turn ignition off for 10 seconds.
    • Turn ignition on.
    • Check for fuel leaks.
scientia non olet · About LEMON Manuals