LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 113 (Engine Controls - Removal & Installation, Overhaul) >> Emission Systems & Sub-Systems >> EVAP Canister Purge Solenoid >> Removal & Installation (2.2L)

Removal & Installation (2.2L)

WARNING: This page is about a different car, the 2002 Pontiac Grand Am, 2002 Oldsmobile Alero, and 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the EVAP canister purge solenoid harness connector. See Fig 1 . Disconnect the vacuum pipe from the EVAP canister purge solenoid. Disconnect the purge pipe from the EVAP canister purge solenoid.
  2. Remove the EVAP canister purge solenoid and bracket. Remove the EVAP canister purge solenoid from the purge bracket. Inspect for carbon release in the EVAP canister purge solenoid ports.
  3. To install, reverse removal procedure. Tighten EVAP canister purge solenoid bracket nut to specification. See TORQUE SPECIFICATIONS  .
Fig 1: Locating EVAP Canister Purge Solenoid (2.2L)
G00121076Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals