LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1129 (Rear Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. For front wheel drive vehicles, remove the brake drum. Refer to Brake Drum Replacement in Drum Brakes.

    For all wheel drive vehicles, remove the rear brake rotor. Refer to Brake Rotor Replacement - Rear in Disc Drakes.

    4. Fig 1: Pressing Wheel Stud From The Wheel Bearing/Hub With J 35917
    GM595784Courtesy of GENERAL MOTORS CORP.
  4. Use J 35917  in order to press the wheel stud (1) from the wheel bearing/hub (2).
scientia non olet · About LEMON Manuals