LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1129 (Rear Suspension System) >> Repair Instructions >> Wheel Bearing/Hub Replacement - Rear (Front Wheel Drive/Drum) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Hub & Bearing Assembly - Rear
    GM230412Courtesy of GENERAL MOTORS CORP.
  1. Connect the wheel speed sensor electrical connector (2).
    2. Fig 2: Identifying Wheel Bearing/Hub Bolts - Rear
    GM813284Courtesy of GENERAL MOTORS CORP.
  2. Install the wheel bearing/hub.
    3. CAUTION: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these fasteners after they become loose or are removed may cause loss of vehicle control and personal injury.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install NEW wheel bearing/hub bolts.

    Tighten:  Tighten the wheel bearing/hub bolts to 85 N.m (63 lb ft).

  4. Install the brake drum. Refer to Brake Drum Replacement in Drum Brakes.
  5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals