LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1129 (Rear Suspension System) >> Repair Instructions >> Wheel Bearing/Hub Replacement - Rear (Disc and AWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the knuckle. Refer to Knuckle Replacement (All Wheel Drive) .
    4. Fig 1: Locating Wheel Bearing/Hub Assembly Knuckle Bolts
    GM809968Courtesy of GENERAL MOTORS CORP.
  4. Remove the wheel bearing/hub assembly knuckle bolts (1).
    5. Fig 2: View Of Wheel Bearing/Hub Assembly And The Knuckle
    GM809973Courtesy of GENERAL MOTORS CORP.
  5. Remove the wheel bearing/hub assembly (1) from the knuckle (2).
scientia non olet · About LEMON Manuals