Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Install the rear axle tie rod to the vehicle.
- Install the rear axle tie rod bolts and nuts.
Tighten: Tighten the rear axle tie rod bolts to 125 N.m (92 lb ft).
- If the vehicle is equipped with automatic level control, perform the following steps:
- Install the height sensor link to the rear axle tie rod.
- Connect the automatic level control sensor electrical connector.
- Lower the vehicle.
NOTE:
Refer to Fastener Notice in Cautions and Notices.
NOTE:
When you are servicing the automatic level control sensor link, ensure that the sensor link and the sensor arm are not damaged. Ensure the sensor arm and the sensor link are properly oriented. Improper orientation of the sensor arm and the sensor link may cause damage to the automatic level control system or the vehicle.