LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1129 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement (All Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer shaft.
    2. Fig 1: View Of Left And Right Side Stabilizer Shaft Insulators And Brackets (All Wheel Drive)
    GM629208Courtesy of GENERAL MOTORS CORP.
  2. Connect the left and right stabilizer shaft links. Refer to Stabilizer Shaft Link Replacement (All Wheel Drive) .
  3. Install the left and right stabilizer shaft insulators and brackets along with the ALC position sensor, if necessary. Refer to Stabilizer Shaft Insulator Replacement (All Wheel Drive) .
  4. Connect the height sensor to the lower control arm, as necessary.
  5. Connect the ALC position sensor harness connector, if necessary.
  6. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  7. Lower the vehicle.
  8. Install the spare tire to the spare tire hoist.
scientia non olet · About LEMON Manuals