LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1129 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement (All Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Left And Right Side Stabilizer Shaft Insulators And Brackets (All Wheel Drive)
    GM629208Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft insulators to the stabilizer shaft.
  2. Install the stabilizer shaft insulator brackets along with the ALC position sensor, if necessary.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the stabilizer shaft insulator bracket bolts and nuts.

    Tighten:  Tighten the stabilizer shaft insulator bracket nuts to 85 N.m (63 lb ft).

  4. Connect the height sensor to the lower control arm as necessary.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals