LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1129 (Rear Suspension System) >> Repair Instructions >> Rear Axle Upper Control Arm Replacement (All Wheel Drive) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper control arm.
    2. Fig 1: Identifying Upper Control Arm To Crossmember Bolts And Nuts
    GM629234Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts and the nuts which secure the upper control arm to the crossmember.

    Tighten:  Tighten the nuts to 85 N.m (63 lb ft).

    3. Fig 2: View Of Upper Control Arm And Knuckle
    GM629210Courtesy of GENERAL MOTORS CORP.
  3. Install the upper control arm to the knuckle.

    Tighten:  Tighten the nut which secures the upper control arm to 85 N.m (63 lb ft).

  4. Connect the height sensor link to the lower control arm as necessary.
  5. Remove the utility stand.
  6. Install the brake hose bracket.
  7. Install the brake hose bracket belts. Refer to Brake Hose Replacement - Rear (Disc Brake) or Brake Hose Replacement - Rear (Drum Brake) in Hydraulic Brakes.
  8. Install the rear stabilizer link.

    Tighten:  Tighten the stabilizer link ball nut to 31 N.m (23 lb ft).

  9. Install the rear wheel.
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals