LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1128 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Shaft Seal Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Right Axle Shaft Oil Seal
    GM630685Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Inspect the sealing surface of the wheel drive shaft inner tri-pot housing to ensure it is free of corrosion. Use a crocus cloth in order to remove any light corrosion and clean the sealing surface with denatured alcohol, or equivalent.
  1. Using the J 44809  , install the right axle shaft oil seal (1). See Special Tools and Equipment .
  2. Lubricate the wheel drive shaft sealing surface of the oil seal with synthetic gear oil GM P/N 12378514 Canadian P/N 88901045 or equivalent.
  3. Install the right wheel drive shaft. Refer to Wheel Drive Shaft Replacement - Rear in Wheel Drive Shafts.
  4. Install the right rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Inspect the differential lubricant level. Refer to Lubricant Change .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals