LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1128 (Rear Drive Axle) >> Repair Instructions >> Differential Carrier Assembly Mount Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Support the front of the differential with a suitable stand.
  3. Loosen, but do not remove, the torque tube-to-bracket through bolt (7) and nut (1).
    Fig 1: Torque Tube And Components
    GM630649Courtesy of GENERAL MOTORS CORP.
    4. Fig 2: View Of Rear Differential Carrier Mounting Bolts
    GM690531Courtesy of GENERAL MOTORS CORP.
  4. Remove the cradle-to-differential mounting bolts (5), nuts (1), washers (2), and bushings (3) from the differential.
  5. Raise the stand slightly in order to gain access to the differential-to-cradle bushings.
  6. Remove the differential-to-cradle bushings (4).
scientia non olet · About LEMON Manuals