LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1127 (Power Steering System) >> Repair Instructions >> Rack and Pinion Outer Tie Rod End Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Outer Tie Rod Assembly To Inner Tie Rod Assembly
    GM297355Courtesy of GENERAL MOTORS CORP.
  1. Install the outer tie rod (3) to the inner tie rod (1). Do not tighten the tie rod jam nut (2).
    2. Fig 2: View Of Outer Tie Rod & Steering Knuckle
    GM297628Courtesy of GENERAL MOTORS CORP.
  2. Install the outer tie rod (2) to the steering knuckle (1).
    3. Fig 3: Locating Tie Rod Ball Stud Nut
    GM417924Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: This is a prevailing torque type fastener. This fastener may be reused ONLY if:
    • The fastener and its counterpart are clean and free from rust
    • The fastener develops 2 N.m (18 lb in) of torque (drag) against its counterpart prior to the fastener seating.

    If the fastener does not meet these criteria, REPLACE the fastener.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    IMPORTANT: Ensure that 2.5-4.5 tie rod end threads are visible beyond the tie rod nut nylon.
  3. Install the tie rod ball stud nut.

    Tighten:  Tighten the tie rod ball stud nut to 30 N.m (22 lb ft) + 120 degrees (2 flats).

  4. Install the front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Lower the vehicle.
  6. Inspect and adjust the toe as necessary. Refer to Front Toe Adjustment in Wheel Alignment.
scientia non olet · About LEMON Manuals