LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1127 (Power Steering System) >> Repair Instructions >> Power Steering Pulley Replacement (LA1) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Pump Pulley Installer
    GM643361Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:
    • Ensure that the face of the pulley hub is flush with the end of the pump shaft.
    • Do not use the arbor press to install the pulley.
  1. Use the J 25033-C  in order to install the power steering pump pulley.
  2. Install the power steering pump to the engine. Refer to Power Steering Pump Replacement (LA1 )  or Power Steering Pump Replacement (LY7) .
scientia non olet · About LEMON Manuals