LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1127 (Power Steering System) >> Repair Instructions >> Power Steering Pressure Pipe/Hose Replacement (LY7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Power Steering Pressure Pipe/Hose Nut From The Power Steering Reservoir Mounting Stud
    GM1392462Courtesy of GENERAL MOTORS CORP.
  1. Remove the power steering pressure pipe/hose nut from the power steering reservoir mounting stud.
  2. Remove the power steering pressure pipe/hose from the power steering reservoir mounting stud.
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Remove the front right tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Remove the right side engine splash shield. Refer to Splash Shield Replacement - Engine in Body Front End.
  6. Place a drain pan under the power steering pump and the power steering gear.
  7. Disconnect the pressure hose from the steering gear.
  8. Disconnect the pressure hose from the hose retainer.
  9. Disconnect the pressure hose fitting from the power steering pump.
  10. Remove the pressure hose from the vehicle.
scientia non olet · About LEMON Manuals