LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1127 (Power Steering System) >> Repair Instructions >> Power Steering Cooler Pipe/Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the engine splash shield. Refer to Splash Shield Replacement - Engine in Body Front End.
  3. Remove the power steering gear heat shield. Refer to Power Steering Gear Heat Shield Replacement .
  4. Disconnect the cooler pipe low pressure line from the power steering gear.
    5. Fig 1: View Of Power Steering Hoses - 3.8L
    GM294335Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the low pressure hose from the cooler pipe.
  6. Disconnect the wiring harness from the cooler bracket studs.
  7. Remove the cooler pipe bracket retaining studs and screws.
  8. Remove the cooler pipe.
scientia non olet · About LEMON Manuals