LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1127 (Power Steering System) >> Diagnostic Information and Procedures >> Power Steering Fluid Leaks

Power Steering Fluid Leaks

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Power Steering Fluid Leaks

Step Action Yes No
1 Did you review the Power Steering System General Description and perform the necessary inspections? Go to Step 2  Go to Symptoms - Power Steering System 
2 Verify that power steering fluid leaks are present.
Is the power steering system leaking?
Go to Step 3  System OK
3 Inspect the power steering system fittings.
Are the fittings leaking?
Go to Step 8  Go to Step 4 
4 Inspect the power steering hoses.
Are the hoses leaking?
Go to Step 9  Go to Step 5 
5 Inspect the power steering sensors.
Are the sensors leaking?
Go to Step 10  Go to Step 6 
6 Inspect the power steering pump and the reservoir for leaks.
Is the power steering pump or reservoir leaking?
Go to Step 11  Go to Step 7 
7 Inspect the power steering gear for leaks.
Is the power steering gear leaking?
Go to Step 12  Go to Step 8 
8 Tighten the fittings. Refer to Fastener Tightening Specifications .
Did you complete the repair?
Go to Step 13  -
9 Replace the power steering hoses. Refer to the appropriate procedures:
Did you complete the repair?
Go to Step 13  -
10 Replace the power steering sensors.
Did you complete the repair?
Go to Step 13  -
11 Replace the power steering pump or reservoir. Refer to Power Steering Pump Replacement (LA1 )  or Power Steering Pump Replacement (LY7)  or Power Steering Reservoir Replacement - Off Vehicle (CB Series) .
Did you complete the repair?
Go to Step 13  -
12 Replace the power steering gear. Refer to Power Steering Gear Replacement .
Did you complete the repair?
Go to Step 13  -
13 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 3