LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1126 (Engine Exhaust System) >> Repair Instructions >> Exhaust Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exhaust Manifold Pipe Gasket
    GM107855Courtesy of GENERAL MOTORS CORP.
  1. Install the catalytic converter seal.
    2. Fig 2: Identifying Catalytic Converter Nuts
    GM372621Courtesy of GENERAL MOTORS CORP.
  2. Install the catalytic converter to the exhaust manifold.
  3. Connect the catalytic converter to the catalytic converter hangers.
  4. Remove the utility stand.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the catalytic converter nuts.

    Tighten:  Tighten the catalytic converter nuts to 34 N.m (25 lb ft).

  6. Install the oxygen sensor electrical connector.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals