LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1126 (Engine Exhaust System) >> Repair Instructions >> Exhaust Crossover Pipe Replacement (LY7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Exhaust Crossover Pipe To Left Bank Exhaust Manifold Nuts
    GM1395470Courtesy of GENERAL MOTORS CORP.
  1. Install the exhaust crossover pipe.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Loosely install the exhaust crossover pipe nuts (3, 5) and bolt (4).

    Tighten:  Tighten the exhaust crossover pipe nuts (3, 5) to 34 N.m (25 lb ft).

  3. Install the exhaust crossover pipe bolt (4).

    Tighten:  Tighten the exhaust crossover pipe bolt (4) to 34 N.m (25 lb ft).

  4. Install the powertrain engine, transmission, and frame assembly to the vehicle. Refer to Engine Replacement in Engine Mechanical - 3.6L (LY7).
scientia non olet · About LEMON Manuals